How can i set up a network connection with only a gameshark abd a broadband server?

ANSWERS: 1

This is an easy but long process. Make sure you have a soldering iron and some sodder. Some flux wouldn't hurt either. 1) Open up both the gameshark and look for a couple tall black "towers". These are the network inhibitors. 2) Remove them by desoldering the pins underneath and pulling them with a pair of pliers. 3) Open up your server now. See the same black towers? Yep, they need to go as well. 4) After they're gone, get some 14ga wire and solder the R14 resistor on the Gameshark to the power on the server. They should be marked on the PCB board. 5) Replace the casings, cutting holes for the wires to poke through. You should be set after that. It shouldn't take more than 30 minutes. Turst me, I've been doing this for 10 years and have done it on numerous occasions.

This is an easy but long process. Make sure you have a soldering iron and some sodder. Some flux wouldn't hurt either. 1) Open up both the gameshark and look for a couple tall black "towers". These are the network inhibitors. 2) Remove them by desoldering the pins underneath and pulling them with a pair of pliers. 3) Open up your server now. See the same black towers? Yep, they need to go as well. 4) After they're gone, get some 14ga wire and solder the R14 resistor on the Gameshark to the power on the server. They should be marked on the PCB board. 5) Replace the casings, cutting holes for the wires to poke through. You should be set after that. It shouldn't take more than 30 minutes. Turst me, I've been doing this for 10 years and have done it on numerous occasions.

No comments
| Permalink | Share | 22

0
No comments

ABOUT ANSWERBAG

Answerbag wants to provide a service to people looking for answers and a good conversation. Ask away and we will do our best to answer or find someone who can.We try to vet our answers to get you the most acurate answers.

Answerbag | Terms of Service | Privacy Policy

RELATED QUESTIONS

RELATED TOPICS

ABOUT ANSWERBAG