In order to do that you would have to take the door panals off and disconect the plug that's pluged into the back of the pannel. But doing this you will not be able to use the remote to lock/unlock the doors or the push button inside. I would recomend not doing it. I don't know how much you know bout working on cars but you could figure out wich wire runs the automatic locks when you unplug it from the pannel and just disconect that wire. Good luck.

no no no no. If you have push button key locks, which you should. the mode is programmed by sequences of pushing the buttons on your key. Google the key codes, you program the alarm ,anti theft and locking sequences also see below for ignition setting If you turn the key on 4. times without starting the truck, the computer goes into program mode. Anyway: from page 10 of the owners manual... Automatic door locks If this feature is selected your door locks will lock automatically if the speed is above 15 mph. This option is shipped activated and can be turned on and off by using the following procedure: 1. Close all of the doors. 2. Place the key in the ignition and cycle the key from the OFF position to the ON position for a total of four times ending in the ON position, do not start the engine. 3. Press the drivers side power door lock switch to lock the doors within 30 seconds. 4. You will hear a single chime when the programming is completed. 5. To activate the feature again, repeat the above steps. ...And from pages 12-13: To unlock the doors and liftgate: Press and release the UNLOCK button on the key fob once to unlock the driver's door, or twice to unlock all doors and liftgate. The illuminated entry system will also come on. The system may be programmed to unlock all the doors, on the first press, using the following procedure: 1. Close all the doors. 2. Place the key in the ignition and turn the key between the OFF and ON position consecutively for a total of four times ending in the ON position (do not start the engine). 3. Press the driver's side power door lock switch to unlock the doors and within 30 seconds to lock the doors. 4. You will hear a single chime when programming is completed. ey buttons