Ford Ranger category

Posted by Anonymous some time ago

My 2002 Ford Ranger has the electronic 4x4 switch on the dash. The light is off for 4WD but it sounds like the truck is in 4WD when I drive it but does not hop or jump going around sharp bends. Any suggestions?

Posted by jake095 some time ago

How big of a tire can I put on a stock 1990 Ford Ranger 2wd?

Posted by cmz2u some time ago

How do you change the headlight on a 2001 ford ranger?

Posted by dwightnex some time ago

VERY HIGH IDLE SPEED ON MY '85 RANGER 2.3L 4CYL.EFI. SO FAR, I'VE REMOVED;CLEANED AND CK'D RESISTANCE ON THE IAC VALVE,(MOTOR);CK'D RESISTANCE ON THE TP SENSOR; CK'D FOR LEAKS IN THE VACUUM LINES.THE O2 SENSOR;SPARK PLUGS AND WIRES WERE REPLACED.HELP!?

Posted by donny23 some time ago

Where is the oil sending unit on a 1995 Ford Ranger with the 3.0 engine?

Posted by bowfinga some time ago

My 86 ford ranger 2.9 had a crankcase air filter instead of a pcv valve. Is this normal?

Posted by Anonymous some time ago

Ford Ranger will not start, not starter, battery, etc. Something to do with wire as it will spark when trying to reattach battery etc all electric off, no tail lights, brake lights bulbs are good, terminals etc are all new; fuses are good,

Posted by Anonymous some time ago

My 1998 Ford Ranger pick-up truck has a shimmy.The power steering pump and rack were changed and it still does it. With the engine running and the front jacked up, when you turn the steering wheel sharply the steering wheel and wheels shake

Posted by Anonymous some time ago

I have a 2000 Ford Ranger 3.0L V6. The blower motor resistor connector has melted to the blower motor resistor. I was wondering how hard it is to rewire the connector and what that entails.

Posted by RangerPilot some time ago

2003 Ford Ranger 3.0, 70,000 miles. Cranks a long time to start, especially when cold, but otherwise runs and idles fine. No check engine light. What component is failing?

Posted by jeffrey some time ago

Where is the location of fuel filter on 2005 ford ranger ext cab

Posted by Anonymous some time ago

2002 ford ranger xlt how to change radiator coolant?

Posted by Cheri Berry some time ago

Where can I get a picture/diagram of the fuse box in my 98 Ford Ranger?

Posted by radio522 some time ago

I have a 91 ford ranger 4cyl it will not crank have changed the coil packs and the crank sensor but it still wont fire any suggestions thanks

Posted by Anonymous some time ago

Where is the ignition control module located on a 1994 ford ranger xlt 4.0 engine?

Posted by Anonymous some time ago

I have a 2002 ford ranger the mechinic said it was my slave clinder another said it was the clutch thats lose witch one is right

Posted by starvin marvin some time ago

I have a 1993 ford ranger pickup.Won,t turn over need to know how to bypass ignition switch

Posted by hawk some time ago

1988 Ford Ranger changed both fuel pumps and will run great till you get to a cetain RPM then starts like it loses fuel and runs out of power

Posted by Duane Stevenson some time ago

How do I replace the ignition lock set on a 1993 Ranger 2WD with the tilting steering column?

Posted by Luckyforward some time ago

How do you remove leaves, debris, etc. from the heater fan on a 2003 Ford Ranger?

Posted by alliebuck some time ago

I have a 1995 Ford Ranger and for the longest time the temp gauge was very constant, now after about ten min. after startup I notice the temp gauge goes high then levels out--- also on the highway I see it go up slighty and then back to normal ina few sec

Posted by dsparks891 some time ago

!994 Ranger Check Engine light On but goes of after driving a few miles.Have changed plugs,wires egr,egr sensor,air charge sensor.Checked 02 sensor reads good. any ideas

Posted by raceray23 some time ago

I have an 1988 Ford Ranger with 2.9L. The truck will start fine and run forever until you kill it. The fuel pump comes on and pressures up the fuel rail but it does not get any fire. I can let it sit for about 10 minutes and it will start up fine.

Posted by D-Adamski some time ago

How often do you change the PCV valve on a truck motor?

Posted by Mike Zawacki some time ago

I have a 2003 V6 Ford Ranger. At 90 MPH the truck looses power and starts to hesitate. What might cause this?

Posted by Rick39 some time ago

2002 Ford Ranger left stop/turn light is not working. The fuse and bulb are good. The ground connection checks ok. The plug and lamp base have continuity. What should I check next?

Posted by Jamielew some time ago

Why is my ford ranger stuck in 4 wheel drive low. The light is on , and when I try to switch it to 4 high, or 2 wheel, it does nothing, and the light still says 4x4 low. Pleeeeease help me before my boyfriend finds out. Its a 1999 or 2000

Posted by silo01 some time ago

Where is the oxygen sensor on a 1997 Ford Ranger with 6 cylinders?

Posted by milly1997 some time ago

How do i replace a head gasket in a 2001 ford ranger?

Posted by seadog38 some time ago

How to adjust headlights on ford ranger 2005

Posted by jaguerrero some time ago

Where is the pcv valve located on a 2001 ford ranger

Posted by pack_jerry some time ago

Hey i have a 1993 ford ranger with a 3.0L V6 standard transmision and 2wd. it has no spark and we have changed almost every ignition part on the truck and it still wont spark. any help would be greatly appreciated thanks

Posted by Ron_65 some time ago

My 88 Ford Ranger suddenly has no power. When I drive it, it bogs down, then suddenly surges and speeds up for a moment before bogging down again. What's wrong?

Posted by ranger 2 some time ago

I locked my keys in my 2002 ranger how can I unlock the door

Posted by Anonymous some time ago

The heat selector switch on my 97 Ford Ranger doesn't work. The heater only blows hot regardless of the setting. A dealer said the "blend air box" needed replacing. Cost $900. Can I do this myself. Can I just replace a servo? The vacuum switches work fine

Posted by 4885 some time ago

Please Help.. I have a 2002 ranger 2.3L .I have problems starting after it sits for a hour or longer. I have to try cranking it 2 or 3 times. I have replaced the IAC, and also the fuel filter on the rail.

Posted by rob some time ago

4x4 in ford ranger stopped working. light does not even come on and no noise of trying to activate or anything.. help

Posted by curious me some time ago

What is fuse layout for a 1995 ford ranger?

Posted by nooner some time ago

My 1994 Ford Ranger is stuck in 4x4 low gear. the lights do not turn on on the button panel where i change them and i have tried everything from turning the hubs to free to turning the car off and pushing the buttons to checking the fuses and still nothin

Answerbag | Terms of Service | Privacy Policy